Injector Dynamics ID1000 Fuel Injectors Set 2000-2005 Honda S2000

Injector Dynamics ID1000 Fuel Injectors Set 2000-2005 Honda S2000
Item# ID1000-S2K
$480.00
Sorry, this item is currently out of stock.

Discontinued item *

Set of 4 Injector Dynamics ID1000 fuel injectors for 2000-2005 Honda S2000. These are a custom fitment injector set specifically for this application which allow proper fitment on the 00-05 S2000. The injector connector is different from the stock Honda electrical connector. You can either remove your stock Honda injector clips and crimp on the new 'USCAR' style injector connectors (included), or purchase a set of USCAR to OBD2 Honda injector adapters for easy plug-n-play use without splicing into your stock engine harness.

ID1000 Specs:

* Nominal Flow Rate - 1015cc/min @ 3.0 Bar (43.5 psi) Using Gasoline at 125 Degrees F
* Maximum Differential Fuel Pressure - 7.0 Bar (101.5 psi)
* Fuel Compatibility - Compatible With All Known Fuels
* Electrical Connector style - USCAR

Injector Dynamics fuel injectors are the result of batch testing large quantities of specially modified fuel injectors, and then carefully matching them to within 1%, in sets based on their dynamic flow across the pulsewidth range. The result is vastly superior cylinder to cylinder consistency, even at very low pulsewidths. In addition to receiving tightly matched injectors, you will be provided with dead time compensation values across the entire pressure and voltage range of the injector. This data will insure that the compensations in your ECU work properly, and your air fuel ratios will remain consistent as atmospheric or voltage conditions change.

Application specific notes:

For this application you will retain the factory Honda lower injector cushion that sits in the intake manifold. Your new injectors will be supplied with a washer and a square o-ring on the bottom of the injector, this will press against the factory lower injector cushion. There are also 3 M8 washers included with the injectors. You will remove the factory fuel rail standoffs and re-install them with the M8 washer between the intake manifold and the standoff, this will give you the proper installed height on the injector assembly.