The Hondata FlashPro J-Swap Kit is the answer to engine management for the popular J Series V6 engine swaps (manual transmission only). The kit includes a used, tested, TL ECU that is set up by Hondata for this swap, a Hondata FlashPro that is permanently locked to this ECU, and a custom Hondata supplied harness for the install. This allows you to wire and run a J-Swap in nearly any chassis.
What engines are supported?
- 04-08 TL J32A3 and J35A8
- 05-08 RL J35A8
- 05-10 Odyssey LX and EX J35A6
- 05-08 Pilot J35A6 and J35A9
- 06-08 Ridgeline J35A9
- 03-06 MDX J35A5
How will I tune?
This uses the popular Hondata FlashPro hardware, which allows engine tuning via the FlashPro Manager software. The FlashPro manager sofware can be downloaded here
What else is needed?
There are 3 harnesses that you will need in addition to the harness included in the J-swap kit:
- Main engine harness that connects to all the sensors, etc. on the engine.
- Sub harness that connects to the main engine harness and goes through the firewall to the ECU.
- DBW/TPS harness that connects the drive by wire unit and TPS.
Throttle Components. (Aside from a throttle pedal assembly):
- Accelarator/throttle pedal position assembly
- Accelerator/throttle pedal cable
- TPS control module
For detailed installation instructions covering what is needed, part number, etc., please see the installation instructions here
Features:
- Programmable ECU interface.
- Supports 10 PSI boost with the stock MAP sensor. 43 psi boost with optional Hondata 4 bar sensor.
- Larger injector calibration suport
- Connects via OBDII diagnostic port.
- USB 2.0 connection
- Works with Laptop or Desktop
- Live tuning
- 20 hours on-board datalogging memory
- Much more!
How much power will the FlashPro make on my car?
The FlashPro itself does not make power. The combination of parts and your engine makes the power. The FlashPro allows you to tune the fuel maps, ignition maps, and more to run your engine properly.
Will this work with an automatic transmission?
No. This only works with manual transmissions.
Do I need dyno tuning?
Yes. The starting swap calibrations on the FlashPro allow you to start the engine and begin the tuning process.
Will this work on more than one vehicle?
No. This FlashPro is locked to the one supplied engine computer.
Any option of immobilizer control?
There is no immobilizer on this set up, so this system can be used in any race car.
QUESTIONS & ANSWERS
Have a Question?
Be the first to ask a question about this.