KTuner End-User board bluetooth module installation instructions

The KTuner End-User Rev1 board accepts the bluetooth add-on module to allow bluetooth data logging using the TunerView Android app.

Installation is straightforward:
  • Remove the top lid/cover of your K series ECU
  • Locate the 4 pin angled male header on the top of the board circled here:

  • On the back side of the bluetooth module, locate the 4 pin female connector circled here:

  • Take note of the 4 digit pairing/pin code that is on the back side of your bluetooth module. Write it down, you will need this later.
  • Slide the bluetooth module's female connector onto the male header pins until seated as shown here:

  • Reinstall the top cover of your ECU. Installation is complete. See the TunerView app for instructions on pairing and datalogging within the app.

Net Orders Checkout

Item Price Qty Total
Subtotal $0.00

Shipping Address

Shipping Methods